Features & specs
General | ||
---|---|---|
Speaker Size | 6 1/2 | |
Design | 2-way | |
Tweeter Design | 28mm Dome | |
Impedance (Ohms) | 4 | |
Tweeter Composition | Silk | |
Woofer Composition | Carbon/Rohacell Sandwich | |
Woofer Surround | Butyl Rubber | |
Parts Warranty | 2 Years | |
Labor Warranty | 2 Years | |
Specifications | ||
Sensitivity (1W at 1 meter) | N/A | |
Sensitivity at 2.83 volts | 89 | |
Frequency Response | 30 - 25k Hz | |
Minimum RMS Wattage | --- | |
Maximum RMS Wattage | 140 | |
Peak Power Handling (Watts) | 600 | |
Top-mount Depth (Inches) | 2 1/2 | |
Bottom-mount Depth (Inches) | 2 11/16 | |
Cutout Diameter or Length (inches) | 5 5/8 | |
Mounting Height (Inches) | 0.415 | |
Frame Width | 6.543 | |
Frame Length | 6.543 |
Product Research
Features
Woofer Size Classification Note: Some manufacturers, including Morel, call this size woofer a 6-1/2". Because it requires a larger cutout than a standard 6-1/2" speaker, Crutchfield has traditionally referred to this size woofer as a 6-3/4". Please enter your vehicle information to confirm fit.
Enclosure: If the woofer is mounted in an enclosure, Morel recommends a 0.14 ft³ sealed enclosure (0.11 ft³ to 0.35 ft³ is acceptable) or a 0.35 ft³ ported enclosure tuned to 65 Hz.
Tweeter Mounting: The tweeter is designed to be flush mounted; it is built on a flush mount frame. The dome is very delicate, so the mesh grille should always be used.
Tweeter Dimensions:
Flush Mount | |
---|---|
Mounting Height | 0.495" |
Mounting Depth | 1.280" |
Cutout Diameter | 2.095" |
Frame Diameter | 2.723" |
Crossover: The outboard crossovers' inputs and outputs are set screw terminals; they will accept bare wire up to 10-gauge. The crossover point is 2.2 kHz and the slope is 24 dB/octave. A jumper inside each crossover allows you to adjust the tweeter output level; choose -2 dB, 0 dB, or +2 dB. Each crossover has bi-amp inputs, one input for the tweeter and one for the woofer. When bi-amping the speakers, the input jumper wires need to be removed. Using four amplifier channels to bi-amp speaker typically improves the dynamic range and presents an easier load for the amp(s) to drive.
Crossover Dimensions:
- Width: 6.885"
- Height: 1.875"
- Depth: 5.205"